ADAP 3/4 MPT X 3/4 BARB NYL

1.21

Quantity
Part no. 0112653700 Categories: ,

Description

ADAP 3/4 MPT X 3/4 BARB NYL

Part No. 0112653700

Overview

Booster Pump supplies a positive pressure to the Pre-filters, and through to the High Pressure Pump. The Horizon Seafari utilizes a pump with a performance curve of 80 Ft Head (35 psi) at 4.2 GPM. The resulting pressure at the High Pressure Pump depends on the final configuration.

  • To Booster Pump Inlet The Booster Pump is a centrifugal pump and it is not self-priming.
  • The booster pump volute must be fully filled with water in order for the booster pump to operate properly.
  • Any air present in the pump prevents the water from flowing.
  • Mounting the booster pump below water level ensures that air never enters the booster pump volute.
  • For best results, install the Booster Pump Below Water Level and close to the Sea Strainer, if installed.
  • The Booster Pump may be mounted either horizontally or vertically.
  • If mounted vertically, the Wet End MUST be mounted DOWN (on bottom).
  • If mounted vertically (with the wet end on top) the motor may develop an electrical short should the wet end of the Booster Pump leak.
  • Connect the Booster Pump inlet to the Sea Strainer Outlet or Sea Cock valve, or if the Inlet Rinse/Clean Valve is installed then connect the Booster Pump Inlet to the Center (common) port of the Inlet Clean/Rinse Valve.
  • Keep this line as short and straight as possible.
  • Avoid up and down loops, 90° elbows, and hose kinks.

COMMERCIAL PREFILTER ASSY 32.5 SQ FT HRO HS B109120002
Commercial Pre-Filter provides extended periods between filter element changes. The Commercial Pre-filter contains a filter element with 50 square feet of filtering area. This filter removes suspended solids 5 Microns & larger.

  • Replaces the Standard Pre-filters.
  • It is not necessary to use both the Commercial Pre-filter and Standard Pre-filters.
  • The Commercial Pre-filter, must be positioned on a firm, flat surface and mounted in place with the supplied hardware.
  • Allow 12 inches above the Commercial Prefilter assembly for filter element removal.
  • Connect the Commercial Pre-filter Inlet Port to the Booster Pump Outlet (or Plankton Filter Outlet if used or Multi Media Filter Outlet if used).

 

OIL WATER SEPARATOR 32.5 SQ FT HORIZON SEAFARI B111800006
The separator element separates oil and suspended solids from the System Feed Water. Oil permanently destroys the R.O. Membrane Element, therefore, it is recommended that the user avoid operating the Horizon Seafari in oily, polluted waters.

  • Follows the Commercial Pre-filter.
  • The Oil/Water Separator Assembly is plumbed for water flow in the opposite direction as the Pre-filter.
  • Using the supplied ¾” hose, connect the Oil/Water Separator Inlet to the Standard or Commercial Pre-filter Outlet.
  • Connect the Oil/Water Separator Outlet to the High Pressure Pump Inlet.

Downloads

BOOSTER PUMP MOTOR ASSY 1PH HP75 – B016080026
EXPLODED PARTS VIEW

BOOSTER PUMP ASSY MOTOR ASSY 3 PH HP75 – B016080027
EXPLODED PARTS VIEW

COMMERCIAL PREFILTER ASSY 32.5 SQ FT HRO HS B109120002
EXPLODED PARTS VIEW

OIL WATER SEPARATOR 32.5 SQ FT HORIZON SEAFARI B111800006
EXPLODED PARTS VIEW