Description

HEAD BOOSTER PMP HP75 SS
Part No. 1205514772

This product is no longer available, we use the following part instead:
BOOSTER PUMP HEAD N200 – 1221515772

This part belongs to the assemblies below :
BOOSTER PUMP MOTOR ASSY 1PH HP75 – B016080026
BOOSTER PUMP ASSY MOTOR ASSY 3 PH HP75 – B016080027

Booster Pump supplies a positive pressure to the Pre-filters, and through to the High Pressure Pump. The Horizon Seafari utilizes a pump with a performance curve of 80 Ft Head (35 psi) at 4.2 GPM. The resulting pressure at the High Pressure Pump depends on the final configuration.

• To Booster Pump Inlet The Booster Pump is a centrifugal pump and it is not self-priming.
• The booster pump volute must be fully filled with water in order for the booster pump to operate properly.
• Any air present in the pump prevents the water from flowing.
• Mounting the booster pump below water level ensures that air never enters the booster pump volute.
• For best results, install the Booster Pump Below Water Level and close to the Sea Strainer, if installed.
• The Booster Pump may be mounted either horizontally or vertically.
• If mounted vertically, the Wet End MUST be mounted DOWN (on bottom).
• If mounted vertically (with the wet end on top) the motor may develop an electrical short should the wet end of the Booster Pump leak.
• Connect the Booster Pump inlet to the Sea Strainer Outlet or Sea Cock valve, or if the Inlet Rinse/Clean Valve is installed then connect the Booster Pump Inlet to the Center (common) port of the Inlet Clean/Rinse Valve.
• Keep this line as short and straight as possible.
• Avoid up and down loops, 90° elbows, and hose kinks.